Sprache:Deutsch

Peripheral Equipment and Accessories

  • Tool set starter edition, Administrated tool board (ATB)

    We have assembled a starter set with 30 items containing radius cutters and cylindric cutters for machining plastics, zirconium, composites and non-precious alloys. With the sets for K3/K4 Impression and S1/S2 Impression, you get the practical administrated tool board for free along with the tools. Its numbered slots will be administrated by the DentalCAM software. So all information remains linked with each tool and you can dispose in total of a much larger active pool of tools.

    For machining glass ceramics a starter set with 10 items containing radius and torus grinding tools is available.

  • Tool set starter edition | Administrated tool board (ATB)

  • Blank Operation Board (BOB)
  • Blank Operation Board (BOB)

    This device consists of a elegant granite base-plate and an eloxed fixing plate of aluminium. Thus you can easily and safely insert new blanks or remove the already milled ones from the blank frames which are used in the automatic blank changer of S2 Impression.

    You do not risk that a valuable blank will fall down when working freehand and your table surface will be protected.



  • Set Blank Frame Tower (BFT)

    A practical add-on for the automatic blank changer of your dental milling machine S2 Impression.

    In its eight slots, you can space-savingly store frames for blanks or blocks which are currently not in use.

    This set contains eight frames for S2.

  • Set Blank Frame Tower (BFT)


  • Block holder
  • Block holder

    Holders for up to three blocks (dimensions up to 40 x 19 x 16 mm) with round shanks for the S models, each as specific type.

    • for S1 Impression for manually clamping in the fixing device (above)
    • for S2 Impression as frame for usage with the automatic blank changer (below)


  • Abutment holders

    The Medentika PreFace® abutment holders are available in two variants.

    • for N4 Impression: the holder (above) can fix two prefabricated abutments
    • for S1/S2 Impression: the holder (below) can fix up to six abutments
  • Abutment holders


  • Switching unit PSW
  • Switching unit PSW

    This small unit allows to switch a vacuum cleaner with a connection power of up to 230 V/16 A automatically by the control electronics of your Impression machine on and off and thus automatize your operational procedures. The PSW just has to be connected via the appropriate 24 Volt output.