In most cases it is rather difficult to equip large-scale milling machines with a housing. If it is be done anyway, it is on the one hand expensive and on the other hand it leads to a reduced practicability, for example for loading large workpieces. Also light-barriers which are sometimes used for this purpose, impair the handling. The sender, mirror and receiver columns which are arranged around the machine, are not only space-consuming but also error prone. So after incidentally bumping at such a column, one had to make a complex re-adjustment.
The new safety laser scanner monitors a previously defined area around the machine. As it is mounted beneath the machine table, it neither obstructs the setup nor the machining procedure. The size of the safety area can be adapted to the local circumstances at the installation site of the machine. For monitoring a safety area of up to 270° on machines of up to three metres length, one scanner module will be sufficient. For an all-round monitoring of 360° respectively for larger machines, two scanner modules will be mounted under the machine. The laser scanner is comfortably operated via switches which are integrated into the system rack, the protection status is signalled through a RGB lamp. The safety laser scanner can be used on machines of the Premium line and the Active Pro line in combination with a 19” system rack.